Canon C3200 - Manual (Page 130)

Scan Settings 3-15
Basic Scanning F
eatures
3
NOTE
Pressing [Cancel]
➞ [Done] ➞ [Cancel] only stores the new document sizes in the
selected key ([Registered Size 1] or [Registered Size 2]), but does not activate
them. If you press [OK]
➞ [Done] ➞ [OK], the new document sizes are stored in the
selected key ([Registered Size 1] or [Registered Size 2]), and activated at the same
time.
Resolution
You can specify the resolution before scanning the original.
IMPORTANT
• The maximum size of an image that you can send at 600 x 600 dpi resolution is 11" x 17".
If the image exceeds this number of pixels in either the horizontal or vertical direction, it
may be cropped.
• If the optional Super G3 FAX Board is installed, and you are sending documents by fax,
the maximum size of an image that you can send at 400 x 400 dpi resolution is 11" x 17".
If the image exceeds this number of pixels in either the horizontal or vertical direction, it
may be cropped.
NOTE
The default setting is '200 x 200' dpi.
1
Place your originals
➞ specify the destination.
For more information on specifying the destination, see Chapter 2, "Basic
Sending Methods."
2
Press the Scan Settings drop-down list
➞ press [Option].