Carrier 58DH User Manual

Downflow/horizontal induced-draft gas furnace

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Carrier Corporation • Syracuse. N.Y. 13221

a

EPFICIENCY

RATING

CERTIFIED

ama

Downflow/Horizontal Induced-Draft

Gas Furnace

GENERAL

Before starting installation of this furnace, read

these instructions carefully and completely. After
installation is complete, remove the Energy Guide
tag from the furnace. Also read the Procedures for
Induced-Draft Gas-Fired Furnaces (packaged with

furnace) for important information concerning
combustion, venting, piping and other standard
installation practices. Further reference can be made
to the current edition of the American National
Standard Z223.1 National Fuel Gas Code.

The induced-draft vent system of this furnace is

designed to operate at zero or negative pressure at
the vent connector outlet. This furnace, therefore,
complies with the National Fuel Gas Code (NFPA
54-1980 or ANSI Z223.1-1980), Part 7.14.3.b. This
furnace is also listed by AGA for use with the type
B1 gas vent, as described in the National Fuel Gas
Code, Part 7.3.2.

Each furnace is shipped from the factory com­

pletely assembled with multispeed direct-drive
blower, and wired ready for indoor heating installa­
tion. All sizes feature a blower control center with
easy-to-read low-voltage terminal strip to ensure
proper connections.

The output capacity and any representations of

efficiency for this product are based on standard

Department of Energy test procedures. The installed
operation may vary, depending on installation,

weather and other factors.

(

\l

NON D

dik

'I

II Mall liiinaCL

1 1 1

a >.ono

^l^.c III i.iiiilaminali.d atmnMilu n. Xdlicu lo.ill

combustion and ciiculatmg air requirements
listed in Procedures foi Induced-Dratt (ias-

I ii..d liiiiiai.is ()h'^eI\l. all loi.al Lodes and

Fig. 1 — Furnace in Downflow Position

Fig. 2 — Furnace in Horizontal Position

The design of the downflow/horizontal (Fig. 1

and 2) gas-fired furnace is AGA certified for in­
stallation on combustible flooring (with optional

floor base), in alcoves, attics, crawl spaces, base-

ments, closets or utility rooms. The design of this
furnace line is not AGA certified for installation in
mobile homes, recreation vehicles or outdoors.

Carrier Corporation 1984

Form 58DH-3SI

Advertising