Carrier UPFLOW 58BTA - Manual

HEATING & COOUNG
58BTA
Upflow/Horizontal Oil Furnace
Installation, Start-up and Operating Instructions
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE
VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER
APPLIANCE.
DO NOT ATTEMPT TO START THE BURNER WHEN EXCESS OIL HAS
ACCUMULATED, WHEN THE FURNACE IS FULL OF VAPOR OR WHEN
THE COMBUSTION CHAMBER IS VERY HOT.
WARNING
For use with grade 2 Fuel Oil maximum. Do Not
use Gasoline, Crankcase Oil or any Oil containing
Gasoline!
CAUTION
Never burn garbage or paper in the heating systems
and never leave rags or paper around the unit.
CAUTION
These instructions are intended to be used by
qualified personnel who have been trained in
installing this type of furnace. Installation of this
furnace by an unqualified person may lead to
equipment damage and/or a hazardous condition
which may lead to bodily harm.
GENERAL
This furnace is a three position unit, in that it may be
operated in upflow, horizontal left-to-right, and horizontal
right-to-left air flow positions. Very few modifications are
required to change the furnace from one position to
another at the job site. The furnace is shipped in the
upflow configuration-instructions on changing to other
configurations are on page 6 of this document.
It is shipped as a packaged unit, complete with burner
and controls. It requires a line voltage (115VAC)
connection to the control box, a thermostat hook-up as
shown on the wiring diagram, oil line connection(s),
adequate ductwork, and connection to a properly sized
vent.
The air handling capacity of this furnace is designed for
cooling air flow. Refer to Figure 6 for the expected
airflows at various external duct static pressures.
Issue 9413
20142901 118
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Book 14' PC 101
Tab 6a 8a
Catalog No. 565-878 Printed in U.S.A. Form 58BTA-1SI Replaces; New