Cisco WUSB300N - Manual (Page 9)

Chapter 3
Configuration
8 Wireless-N USB Network Adapter
Network Type This is the network type used by your
wireless network.
Radio Band This is the radio band used by your wireless
network.
Security This is the status of the wireless security
feature.
MAC Address This is the MAC address of the wireless
network’s access point.
Refresh Click Refresh to perform a new search for
wireless devices.
Connect To connect to one of the networks on the list,
select the wireless network, and click Connect. If the
network’s wireless security is enabled, then one of these
wireless security screens appears:
WEP
If the network has WEP encryption enabled, then you
see the WEP Key Needed for Connection screen. Select the
appropriate level of WEP encryption, 64-Bit or 128-Bit.
Then enter the network’s Passphrase or WEP Key. Click
Connect. To cancel the connection, click Cancel.
WEP Security
WPA
If the network has the WPA Personal security enabled,
then you see the WPA Personal Needed for Connection
screen. Select the appropriate encryption type, TKIP or
AES. Enter the network’s Pre-shared Key in the Pre-shared
Key field. Then click Connect. To cancel the connection,
click Cancel.
WPA-Personal Security
WPA2 Personal
If the network has WPA2 Personal wireless security enabled,
then you will see the WPA2 Personal Needed for Connection
screen. Enter the network’s Passphrase or pre-shared key
in the Passphrase field. To connect to the network, click
Connect. To cancel the connection, click Cancel.
WPA2 Personal Security
Profiles
The Profiles screen lets you save different configuration
profiles for different network setups. The table on the left
displays a list of available profiles with their profile names
and wireless network names.