Sears 385.11608 - Manual (Page 10)

open toward you.
Sewing accessories are conveniently
located in the box.
To Remove the Extension Table
(for tree-arm sewing)
1. Grip the table with your index
finger and thumb, as shown,
2. Pufl genliy to the left. The
extension table will snap out.
To Attach the Extension Table
(for fiat-bed sewing)
1. Insert the tab and the pin into
their catches.
2, With your thumb and index
finger, gently snap in.
the stitch you w)sh to sew.
To change presser test, raise
the presser bar to its highest
position by lifting the presser
toot lever.
Loosen the presser toot thumb
screw, choose the proper foot,
insert from the bottom.
Tighten the screw using the
large screw driver to make
certain the foot is secure.
Choose the Needie and Thread
• To Change the Needle
NOTE: Raise the needle bar to its highest
position by turning the hand wheei
toward you.
1. Loosen the needle clamp screw by turning it
toward you.
2. Remove the needle by pulling it downward.
3. Insert the new needie into the needle clamp
with the flat side away irom you.
4. Push the needie up as tar as it will go.
5. Tighten the needle clamp screw firmly with
the large screwdriver from the accessory
box.