Sears 385.11608 - Manual (Page 3)

IMPORTAMI SAFETY
INSTRUCTIONS
Your sewing machirre Is designed and constructed only tor HOUSEHOLD use.
Read all instructions before using this sewing machine.
DANGER
-To reduce the risk of electric shock:
1. A sewing machine should never be left unattended when plugged in. Always
unplug this sewing machine from the electric outlet immediately after using
and before cleaning.
2. Always unplug before replacing sewing machine bulb. Replace bulb with
same type rated 15 Watts.
3. Do not reach lor a sewing machine that has fallen into water. Unplug
immediately.
4. Do not place or store sewing machine where it can fall or be pulled into a tub
or sink. Do not place or drop into water or other liquid.
WARNING
—^To reduce the risk of bums, fire, electric shock, or injury
to persons.
1. Do not allow to be used as a toy. Close attention is necessary when this
sewing machine is used by or near children.
2. Use this sewing machine only for Its intended use as described In this manual.
Use only attachments recommended by the manufacturer as contained in
this manual.
3. Never operate this sewing machine if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water.
Return the sewing machine to the nearest authonzed dealer or service centerfor
examination, repair, electrical or mechanical adjustment.
4. Never operate the sewing machine with any air opening blocked. Keep ventilation
openings of the sewing machine arid foot controller free from accumulation
of lint, dust, and loose doth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors,
7. Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
8. To disconnect, turn all controls to the off f'O") position, then remove plug
from outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts. Special care is required around
the sewing machine needle.
11. Always use the proper needle plate. The wrong plate can cause the needle
to break.
12. Do not use bent needles.
13. Do not pull or push labric while stitching. It may deflect the needle causing it
to break.
14. Switch the sewing machine off ("0") when making any adjustment In the
needle area, such as threading needle, changing needle, threading bobbin,
or changing presserfoot, and the like.
15. Always unplug the sewing machine from the electrical outlet when
removing covers, lubricating, or when making any other adjustments
mentioned in the instruction manual.
SAVE THESE INSTRUCTIONS