Sears KENMORE 385.128418 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/718254/31/background.png)
SECTION 3. LEARN THE STITCHES
* Sew a Button
Set ihs S/iachins
Stitch selector
Top thread tension
control 1 to 4
Stitch length
Any number
(not necessary
to adjust}
J
Use the darning plate for button sewing (see p.24).
1.
Set the pattern selector at " (»
) ",
2.
Align the both holes of the button with the slot of the foot and place the left
hole of the button lust below the needle point.
3.
Lower the foot and turn the pattern selector to zigzag until the needle point
comes just above the right hole of the button.
4.
Sew about five stitches and raise needle.
5.
Set the pattern selector at " (g ) " again and sew a few stitches to lock
thread.
To strengthen the shank, cut the
threads leaving a 20 cm ¡8") tall. Bring
the needle thread down through the
hole in the button and wind it around
the shank.
Draw the thread to the wrong side and
knot.
29