Sears 385. 12714 - Manual (Page 13)

SECTION 2. PREPARE THE MACHINE FOR SEWING
Prepare the Top Thread
o Thread the Needle
The numbered steps above follow the numbers
on the illustrations.
Dotted lines show places where the thread
loops and then is pulled tight.
2 .
3.
4.
5.
While holding thread near spool, draw thread down into the tension area and then around the
check spring holder.
Firmly draw thread up and through take-up lever from right to left.
Draw thread down and slip it into left side needle bar thread guide.
Thread needle from front to back.
NOTE; You may want to cut the end of thread with sharp scissors for easier needle threading.
11