Sears 385. 12714 - Manual (Page 9)

SECTION 2. PREPARE THE MACHINE FOR SEWING
Set Up the Machine fContinued)
o Free-Arm Sewing: the Removable
Extension Table
o Accessory Storage Box o Change the Presser Foot
¡for free-arm sewing)
1. Grip the table with your index finger
and thumb, as shown.
box lifts open toward you.
Sewing accessories are conveni
ently located in the box.
2. Pull gently to the left,
table will snap out.
The extension
To Attach the Extension Table
¡for flat-bed sewing)
1. Insert the tab and the pin into their
catches.
2. With your thumb and index finger,
gently snap in.
To change the various presser
feet, raise the presser bar to its
highest position by lifting the
presser foot lever.
Loosen the presser foot thumb
screw, choose the proper foot,
insert from the bottom.
Tighten the screw using the
large screw driver to make
certain the foot is secure.
Choose the Needle and Thread
o To Change the Needle
1
NOTE: Raise the needle bar to its highest
position by turning the hand wheel
toward you.
Loosen liie needle clamp screw by
turning it toward you.
Remove the needle by pulling it down­
ward.
insert the new needle into the needle
clamp with the flat side away from you.
Push the needle up as far as it will go.
Tighten the needle clamp screw firmly
with the large screwdriver from the
accessory box.