Sears 385. 12714 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3. LEARN THE STITCHES
o Sew a Button
Set the Machine
Stitch
Stitch selector
lillililii
lUUite,,
(Model 12714)
Top thread tension
control 1 to 4
Zigzag foot
(Model 11607)
Stitch length control
any number (not
necessary to adjust)
Darning plate
Use the darning plate for button sewing (see p. 22
1. Set the stitch selector at " da
2.
Align both holes of the button with the slot of the foot and place the left
hole of the button just below the needle point,
3.
Lower the foot and turn the stitch selector to zigzag until the needle point
comes just above the right hole of the button.
4.
Sew about five stitches and raise needle.
5.
Set the stitch selector at " co " again and sew a few stitches to lock thread.
To strengthen the shank, cut the
threads leaving a 20 cm (8") tail. Bring
the needle thread down through the
hole in the button and wind it around
the shank.
Draw the thread to the bottom side
and knot
26