SINGER 9224 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING AND REPLACING BOBBIN CASE
REMOVING AND REPLACING LIGHT BULB
Open slide plate and remove
Lift needle plate (1) by right
Push lever (2) towards you until
Lift bobbin case up and guide it
out toward you, as shown.
Push lever (2) towards you.
Guide bobbin case into place,
making sure block (3) is under
metal bracket (4).
position over top of bobbin case.
To replace needle plate, slide it
under pin (5) and push it to the
Loosen screw and face plate.
(Screwdriver not included)
Pull down light reflector (1).
Pull bulb down.
(Use only a 5 watts 12 volts
light bulb part #979603)
Push light reflector (1) into
Make sure the small end of
light reflector is aligned with
the small end of light socket