SINGER W1405 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THREADING THE BOBBIN CASE
Hold the bobbin between the thumb and forefinger of your right
hand and pull off about 15 cm (6 inches) of thread.
1. Hold the bobbin case in your left hand as shown and place
the filled bobbin inside.
2. Pull the thread into the slot in the edge of the bobbin case.
3. Now pull the thread under the tension spring and into the
thread eyelet.
To insert the bobbin case and bobbin...........
Ensure that about 15 cm {6 inches) of thread extends
out of bobbin. Hold the bobbin case so that long
finger on case points up. Open the latch of bobbin
case. Slip the bobbin case over the center pin of
hook and press in place until long finger of the
bobbin case enters notch. Release latch and press
down.
-15-