Differential feed, Gathered overedge, To set the^ differential feed adjusting lever – SINGER 14SH644 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
16. DIFFERENTIAL FEED
•
Differential feed Is a system which “stretches” or
“gathers” the fabric, when amount of feed of front
feed dog in relation to the rear feed dog is changed.
• The differential feed ratio ranges from 1 ; 0.7 ~
1 ; 2.0. Adjustment is made by means of the
differential feed adjusting lever pictured below.
• Use of differential feed is very effective in overedging
stretch fabrics and fabrics cut on the bias.
• Graduation “1.0" is differential feed adjusting lever
setting tor ratio 1:1.
[ Gathered Overedge
J
♦ Gathered overedge is most suited for shirring
sleeves, yokes, front and back bodices, skirt hems,
etc. in stretch fabrics such as knits and jersey before
assembling into garment.
To set the^ differential feed adjusting lever
• Set differential teed adjusting lever knob below
graduation “1.0”. Setting of adjusting lever knob
depends on material being sewn as well as the
amount of gather therefore set knob to suit the fabric
and test sew before sewing your garment.
• When feed regulating dial is set at "3" or over, the
amount of feed of the main feed dog will change to
"3" automatically when adjusting lever knob is set
to 2.0.
Note: For normal overedge stitching, set differential
feed adjusting lever knob to graduation "1.0".
23