Setting the needle, How to wind the bobbin – SINGER W5135 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETTING THE NEEDLE
See Fig. 3. Raise the needle bar A to its
highest point, turning wheel toward you by hand.
^ Then loosen the needle clamp sc’^ew B and
the needle can be inserted into clamp C. Place
needle (flat side to right) in the needle clamp
and push it upward as far as it will go into the
needle clamp hole, tightening the needle clamp
screw securely with a screw driver.
After changing needle make one complete revolution
of balance wheel by hand to be sure the needle is in the
HOW TO WIND THE BOBBIN
Turn the clutch in the center of the hand wheel (Fig. 4) toward
you to disengage the sewing mechanism. Place a spool of thread
on the spool pin on the bed of the machine (Fig. 5). Pass threexl
through tension disc A. Insert thread
through a hole on edge of bobbin and
place bobbin on spindle (B) of winder.
Be sure that the notch in the bobbin
fits over the small pin on the spindle.
(C) against hand wheel
by pressing lever (D) and set machine
in motion. When the bobbin is fully
wound, the action of the winder stops
and cut off lojse thread end used to
start winding. Before starting to sew
again, tighten clutch by turning it away from you.
tension disc (A) to the right or left by loosening the screw.
When the disc is in the proper position, tighten screw.