Threading the machine – SINGER 7110 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
threading the machine
•
Rai^ the presser foot to release tension
discs and make sure needle and take-up
lever are in highest position.
• Place spoof pin felt from accessories over
spool pin, and place spool of thread on
/. spool pin over felt, with spool thread re
taining slit A on top.
•
• Keep right hand on spool of thread to hold
firmly in place while threading machine.
• Snap thread into upper thread guide
1
.
• Pass thread through point
2.
• Thread the needle thread tension
3.
Slide
thread over metal plate into tension discs.
Lead thread under needle thread tension
and through tension wire by firmly pulling
thread straight up.
• Pull thread to right behind point
2
guiding
thread up toward take-up lever.
• Pass thread through points
4
to
6
as shown.
• Thread needle from front to back and draw
about 10 cm (4 inches) of thread through
eye of needle.
13