SINGER W117 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

To Draw Up Lower Thread

While holding loosely in the left hand, the end of th

thread extending through eye of needle (three or fo„*
inches), turn the top of hand wheel from you (clockwUe\

with the right hand, until the needle goes all the way down
and comes hack up. The lower thread will form a loop over
the thread you are holding and come up through the needle

hole. Lead the ends of both threads back under the presser '
foot, keeping the upper thread in presser foot slot.

To Remove the Bobbin Case from Shuttle

Turn hand wheel (dock-

wise) until take-up (5^ pig

3) is at its highest point,
Then remove the hand hole
cover plate permitting you to

reach down to bobbin.

Clasp the bobbin case with

the thumb and first finger of
your left hand as shown in

Fig. 7. Then with the second

finger lift up on latch "X"
and the- bobbin case can be

readily removed.

Follow the same procedure

in replacing the bobbin case
in shuttle.

The hole in the center

spindle inside the bottom case

fits over the center pin of the
shuttle, as shown in Fig. 6.

Eight

Remove Shuttle from the Shuttle Race

Flffur* 8

„move the hand hole cover plate and tip head

First remo

^

remove bobbin case as already ex­

back on ite hi

(clockwise) until the

plained.

is just entering needle plate hole. Then .

point of the neM

jp pig. g. This will release

press rear en

readily removed

the shuttle ra

the center pm m

from under p

^ readily removed WITH-

shuttlc (Cp/ '

OUT FORCE.

To Replace the Shuttle

m ... the hand wheel untU the point of the needle a just

the needle plate hole. With the thumb and first

entering tM n ^. ... the shuttle by the center pm

Usar« 1

entering the

v

shuttle by the center pin

■f*®;a!h other in the outer edge of the shuttle, are

oppMite each o^her

pips (

d

P). When properly

thè SHARP point of shuttle will be almost directiy

lined up. the ou

imperative that the

°i®L.n^L*nrooerly placed in the race, and it must never be

fnto^ position. When the shuttle is in position re-

^,°®^!Sttìe rS cover by slipping the fork at left side

SS p“» (H)

b.ck .«r Llpk (G)

whiS will snap back to its holding position.

Nine

Advertising