SINGER W1317 - Manual (Page 10)

Fig. 9
PLACING BOBBIN
CASE IN SHUTTLE
Raise needle bar to
higbest position, and lift
hinged cover plate. (See
11, Fig. 1.) Hold the bob­
bin case latch, (D), Fig. 9,
between the thumb and
forefinger of the left hand,
with at least three inches
of thread running from
the top of the bobbin case to the right. Insert and
center the bobbin case on the stud of the shuttle
body, (C). Be sure the bobbin case finger, (E), is
opposite the shuttle race notch, (A). Press the bobbin
case (B) into the shuttle as far as possible until latch
catches on the center post of the shuttle. THEN
release the bobbin case latch, (D). Press bobbin
case again after latch has been released to make
sure the bobbin case is locked securely in place.
Close the cover plate.
UPPER THREADING (Fig. 10 ■
1) Place spool of thread on spool pin nearer the
needle
2) lead thread through upper thread guide A on
back of face plate
3) down and around tension discs B from back to
front
:r
u
C f
Fig. 10