Preparing to sew, Removing the work – SINGER W1317 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
12
a°d Mendina In order to move the fabric freely in
any drreobon for darning and mending, release the pressure cap
B completely by pressing down on the snap look, A Fig 20
Turn the knob to -DN" position, which drops 'the feed well
to °HI" °
* '”'**'*
feed to normal, return knob
PREPARING TO SEW
Fig. 20
Do n“tT ‘f ‘r:
-w-
del:
Z
:
1
« *
1>‘3
may
aeilect the needle and cause it to break.
never
run machine without material under the presser loot
Tult“
1
“ rd yrrtiiT'
ready to begin sewing. By haying the neel IL hl' f ““
““
the hand wheel to start the machine. Yon merely 1"
is regulated by increasing or decreasing the amounTrf °°°*”
1
g e amount of pressure exerted on the control.
REMOVING THE WORK
Be sure to stop the machine when the thread taVm . i
i
highest position. Now raise the nre
i + j j
^
needle bar are at the
NOW ra.se the presser foot and draw the fabric back and to the left.