Maytag MAH-3 - Manual (Page 13)

STORING THE C lothes W asher
Washers can be damaged if water is not removed from hoses
and interna! components before storage. Prepare the washer
for storage as follows:
• Select the Qyick Wash cycle and add bleach to the
automatic dispenser. Run the washer through the cycle
without a load.
• Turn the water faucets off and disconnect the inlet hoses.
Disconnect the clothes washer from the electrical sup­
ply and leave the washer door open to let air circulate
inside the tumbler.
If the washer has been stored in below-freezing tem­
peratures, allow time for any water left over in the
washer to thaw out before use.
For information on long-term storage or storage of your
washer during extreme cold temperatures,
call Maytag Customer Service toll-free at
I -800-688-9900 USA or I -800-688-2002 Canada.
U.S. customers using TTY for deaf, hearing impaired or
speech impaired, call 1-800-688-2080.
ROUBLESHOOTING
For problem laundry solutions (I.e. fabric damage, residue, tangling) and special laundry care procedures,
see the enclosed Launderiing Tips booklet.
C heck these points IF YOUR M aytag N eptune ® W asher ...
Freshening your
washer
See Cleaning the Interior, page 1 1.
The washer will not
start
• Make sure door is firmly closed.
• Make sure the washer is plugged in.
• Make sure the water source faucets are turned on.
• Make sure to press the Cycle Selector dial to start the washer.
• Make sure the Control Lock is not activated, see page 6.
• Before the washer starts to fill, it will make a series of clicking noises to check the door lock
and do a quick drain.
No water or insuffi­
cient water supply
• Turn both faucets on fully.
• Make sure the door is tightly dosed.
• Make sure the washer is plugged in.
• Check fuse or reset circuit breaker.
• Press the Cycle Selector dial to start the washer.
• Straighten water inlet hoses.
• Disconnect hoses and dean screens. Hose filter screens may be plugged.
• Open and dose the door, then press the Cycle Selector dial.
Detergent remains In
the automatic dis­
penser after the wash
cycle Is complete
• Make sure the washer is running with sufficient water pressure.
See Installation Instructions.
Make sure the Detergent Selector is in the upper position when using granular detergent.
Washer vibrates or
¡s too noisy
• Make sure the washer is set on a level surface. If the surface is not level, adjust the washer
feet to level the appliance. See Installation Instructions.
• Make sure that the shipping bolts are removed. See Installation Instructions.
• Make sure the washer is not touching any other object.
• Make sure the laundry load is balanced.
CONT.
1 2