SINGER W801 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
rface
Fig- 8
S L O T
Fig. 9
TENSION SPRING
Fig. 10
ond,
and
as
ring
placing
bobbin
case
in
shuttle
n_,se needle bar to highest position, and slide cover plate
L
1
U
17
Fig 1) Hold the bobbin case latch, (D,
n between the thumb and forefinger of the left hand,
^'®,h at least three inches of thread running from the top of
r hobbin case to the right. Insert and center the bobbin
on the stud of the shuttle body, (C). Be sure the
Zbb>°case
finger, (E),is opposite the shuttle race notch (A)
Press the bobbin case (B) into the shuttle as far as possible
t 1 latch catches on the center post of the shuttle. THEN
"Tlease the bobbin case latch, (D). Press bobbin case again
'o U»rh has been released to make sure the bobbin case
,S
locked securely in place. Close the cover plate.
*-"'9