Belt cover installation, Caution, Lubrication – SINGER 112 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Zigzag Sewing Machine
Instruction Manual and Parts List
3.3.
Belt Cover Installation
Above table surface
Align the belt guard so that hand wheel and v-belt
move freely, then screw it down is this position (see
Figure 5).
Below table surface
Install belt guard so that motor pulley and v-belt will
rotate freely without interference.
Caution:
•
Switch off the machine.
•
Set sewing head upright again using both hands.
•
Danger of crushing between sewing head and table top.
•
For your safety, do not run the machine without the belt cover.
3.4.
Lubrication
■Ò
Rotating hook and area under throat plate.
Turn hand wheel over toward you until oil hole in
rotating hook appear in sight.
Apply one or two drops of oil to the oil hole (see
Figure 6).
11 -