SINGER 6106 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
THREADING THE BOBBIN CASE
1. Hold bobbin so that thread unwinds in the
direction shown, and put bobbin into bobbin
case.
2. Pull thread into notch A, draw it back under
the tension spring and back into slot B.
3.
Draw approximately 10 cm (4 inches) of
thread across the bobbin.
4. Close slide plate allowing thread to enter slot
between the needle plate and slide plate.
12
Advertising