Buttons, Attaching a button – SINGER 6106 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
buttons
• Pallern Group Selector:
• Needle Position: :j»; X J.
• Stitch Width: To suit button
• Stitch Length: 0
• Snap-in Feed Cover
• General Purpose Foot
ATTACHING A BUTTON
Flat buttons can be sewn on by machine using
the zig-zag stitch.
•
Attach snap-in feed cover to general pur
pose needle plate.
1. Set stitch width selector at j.
• Set needle position at left i.,
•
Place button positioned on fabric under
foot and lower needle into centre of left
hole.
• Lower presser foot.
• Turn hand wheel toward you until the ne
edle rises out of button hole and is just
above the presser foot.
2. Set stitch width selector to a medium width
zig-zag setting.
•
Continue turning hand wheel until the
needle is above right hole, adjust stitch
width, as necessary, until needle enters
the centre of the right hole.
•
Take six or more zig-zag stitches and
finish with the needle on the left.
3. Move stitch width selector to i and take a
few stitches to fasten threads.
•
Pull thread ends through to back of gar
ment knot close to fabric and snip off
loose ends of thread.
34