How to wind the bobbin – SINGER W1514 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
'!KrnaiLi^mrig[W№;!W!W-.-ry.:j:
HOW TO WIND THE BOBBIN
Turn the clutch in the center of the hand, wheel (Fig. 4)
toward you to disengage the sewing mechanism. Place
a spool of thread on the spool pin on the bed of the
machine (Fig. 5). Pass thread through tension disc A.
Insert thread through a hole on edge of bobbin and
^ace bobbin on spindle (B) of winder. Be sure that
the notch in the bobbin fits over the small pin on the
spindle. Place pulley (C) against hand wheel by press
ing lever (D) and
set
machine
in
motion.
When
the
bobbin
is
fully
wound,
the
action
of
the
winder
stops
automatically.
Remove
from
spindle
and
cut
off
loose
thread
end used to start
winding.
If the bobbin winds unevenly, ad
ing tension disc (A) to the right
the screw. When the disc is in
tighten screw. Before starting
clutch by turning it away from