Cleaning and oiling the shuttle – SINGER W1066 (older model) User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
■
f;
lOv* •
16
Before oiling the tipper part of the sewing unit at points indicated by arrows in Fig. 22 turn
hand wheel toward you until the take-up lever is at its lowest point.
Avoid over-oiling-only a drop is needed at each point.
To oil parts under the bed of the machine, tip the unit back on its hinges and apply a drop
of oil at each point indicated in Fig. 23.
CLEANING AND OILING THE SHUTTLE
(See Fig. 24 and 25)
The stitch forming mechanism occasionally becomes
clogged with loose threads and lint. This will interfere
with the efficient operation of the machine. Cleaning
and removal of the lint will safeguard the performance.
To remove the shuttle assembly, proceed as follows;
1.
Turn the balance wheel until the needle reaches its
highest position. Tilt head back on its hinges
2.
Remove bobbin case (A)' Fig. 24.
3.
Turn the two shuttle race cover clamps (B) downward
and
remove
the
shuttle
race
cover
(D)
and
shuttle
body (D).
Fig.
24