SINGER W1066 (older model) - Manual (Page 17)

r
fii 3
*11
ii}^
?11"
if ’
'i ^
i ;
*%i ^
>i 3
K
17
shuttle race
outer edge
as
4. Clean the shuttle race, the shuttle, and
cover by removing all threads, lint etc.
5. Apply a drop of oil with finger tip to
of shuttle.
When the cleaning has been completed, proceed
follows to replace the shuttle assembly;
Turn the balance wheel until the needle reaches its
highesj: position.
Place shuttle body, ( D ) , in race against shuttle driver.
Replace shuttle race cover, i C ) , over hinge pin at lower edge and lock into position with
s u e race cover clamps, (B) making certain the clamps have been snapped securely into
4.
5.
1
.
2 .
3.
4.
5.
position.
Put bobbin into bobbin case.
Put the bobbin case into the shuttle race, fitting tongue into notch E of race cover.
ACCESSORIES
Plastic Oiler
(Sealed and filled)
Package of Needles (5:
Large Screw Driver
Small screw Driver
Felt washers (2)
(For spool pins)
Bobbins (3)
o
5
o