The set of hemmers, Darning spring – SINGER W1066 (older model) User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
o
o
Is 3
%
U 3
! J'
’ •i ~
u I
3
Ni’
THE SET OF HEMMERS
Before
attaching
any
of
the
hemmers.
Be
sure
bobbin thread is pulled up. Then, with hemmer in
place, hold top thread loosely and turn hand wheel one
full turn toward you, making a loop under hemmer.
Grasp bobbin thread with both hands and slip
horizontally under hemmer toward back. Bobbin
thread will catch loop and carry upper thread to back
of hemmer.
Fold material to suit for two inches along edge,
hold at each end of fold. Slip fold into guide and
up over spoon (Fig. 36). Fold hem in material back of hemmer. Draw forward to
and fasten with point of needle. Pnll on threads gently as you start st.tohing.
Fig. ;i6
27
■
J
.
,
'ii
■■■ -’k I.':--;;»
end of hem
;
1
-
'^1*’
DARNING SPRING
HOW TO ATTACH
Remove presser foot, unthread needle, place darner
spring, on needle and slip hook up over needle clamp.
Fig. 37