To oil the ruffler – SINGER 301 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
58
Fig, 70, Plaiting with Raßler
To Adjust Ruffler for Plaiting
1. Raise adjusting lever E and move it until
projection D can be entered in slot marked
^^6.” The ruffler will then plait once every six
stitches. To plait once every 12 stitches, have
projection D enter slot “12” in adjusting lever
E.
2. Insert material to be plaited between two
blue blades and under the separator guide
(Line 2, Fig. 71).
3. To increase width of plait, move adjusting
finger F back toward needle and turn adjust
ing screw C downward. To make a smaller
plait, turn adjusting screw C upward. The dis
tance between plaits is regulated by length of
stitch.
Fig. 71. Correct Position for Material
59
To Adjust Ruffler for Group Plaiting
1. To make the space between the groups of
plaits, raise adjusting lever E and move it
until projection D can be entered in small slot
indicated by star on adjusting lever E. The
ruffler will then stop plaiting and plain stitch
ing will be made.
2. When desired space is made, set projection
D in either of slots 6 or 12.
3. Insert material to be plaited between two
blue blades and under the separator guide
(Line 2, Fig. 73).
T O O I L T H E R U F F L E R
Occasionally apply a drop of oil to working
parts of ruffler at places indicated in Fig. 72.
Fig. 73. Correct Position for Material
Fig. 72. Group Plaiting with Ruffler