Up1»er threading, To remove the bobbin, To wind the bobbin – SINGER 301 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

11

U P 1 » E R T H R E A D I N G

See Figs. 6 and 7

Raise take-up lever 8 to its highest point.

Place spool of thread on spool pin 1
Lead thread into thread guide 2
Into thread guide 3
Down into thread guide 4

Down, under and from right to left between tension discs 5
Hold spool tightly and pull thread up against take-up spring

7 until it enters retaining fork 6

Pass thread up into thread guide 4

From right to left through hole in take-up lever 8
Down through eyelet 9
Into wire thread guide 10
Into wire thread guide 11
Into guide 12 on needle clamp
From right to left through eye of needle 13.
Draw about two inches of thread through eye of needle.

12

Fig. 8. Removing the Bobbin Case

T O R E M O V E T H E B O B B I N

Raise needle to its highest point.

Raise bed extension J. Grasp bobbin case latch

K and lift out bobbin case. Release latch and
remove bobbin.

T O W I N D T H E B O B B I N

See Fig. 9 on the following page

To stop motion of needle, hold hand wheel L
and loosen knurled screw M by turning it over
toward you. Lift bobbin winder out of recess
and bring its pulley N into contact with hub of
hand wheel.

Place bobbin on bobbin winder spindle as far
as it will go.

Place spool of thread on spool pin 1.

Draw thread under and between tension discs

Pass thread through one of the holes in left

side of bobbin 3, from the inside.

Hold end of thread as shown in Fig. 9 and
press controller pedal as for sewing. End of
thread must be held until it is broken off.

Advertising
This manual is related to the following products: