SINGER 9210 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEWING ON A BUTTO
Cut buttonhole opening.
ADJUSTING BUTTONHOLE BALANCE
If the two sides of buttonhole
are unequal, adjust with stitch
balance lever (1).
If the right side is too open-
move the lever to the left.
If the left side is too open-
move the lever to the right.
PATTERN
SETTINGS
ACCESSORY
LENGTH
WIDTH
i
0
i l i i l .
a
1 0 " '
Note; foot shown is optional accessory
For standard accessory use general purpose presser foot (B).
Center
holes
in
button
between toes of foot.
Lower needle into either hole
of button.
While
slowly
turning
hand
wheel, adjust width so needle
enters both holes of button.
Sew 8-10 stitches.
Pull thread to back side and
tie.
16-