SINGER 9210 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING AND REPLACING BOBBIN CASE
REMOVING AND REPLACING LIGHT BULB
Open slide plate and remove
bobbin.
Lift needle plate (1) by right
corner.
Turn lever (2) counterclockwise.
(Screwdriver not included)
Lift out bobbin case.
Guide forked end (3) of bobbin
case under feed dog (4).
Place rim of bobbin case under
position plate (5).
Turn lever (2) clockwise
locking bobbin case in place.
To replace needle plate, slide it
under pin (6) and push it to the
left.
Loosen screw and face plate.
(Screwdriver not included)
Pull dwon light reflector (1).
Pull bulb down.
Push
new
bulb
into
light
socket (2).
(Use only a 5 watts 12 volts
light bulb part #979603)
Push light reflector (1) into
place.
Make sure the small end of
light reflector is aligned with
the small end of light socket
(
2
).
-
20
-