SINGER W162 - Manual (Page 18)

Move zigzag stilch width lever "B" to its extreme left hand position and set the stitch
length where you prefer it, but remember that most embroidery designs require a stitch length
of 1 or less for best appearance.
To remove cam, open door covering cam chamber, move lever "B" to the right as far as
it will go and lift cam off the spindle.
BLIND HEMS
C O M P L E T E D
Blind hems are one of the most helpful things your machine will make, they are used on
dresses, skirts, mens trousers, drapes and any other item when an inconspicuous hem is required.
Place control lever A (Fig. 1) in the H position, the zigzag lever to the extreme left and
set stitch length at approximately number 5.
Prepare the garment in the same manner as for hand hemming.
Step 1. (Fig. 26) If hem with folded edge is used make first fold 3/8" deep.
Step 2. Turn hem the depth desired and baste 1, 4" from upper edge. Press into place.
Step 3. Fold hem back toward right side of garment leaving 1/4" extended.
Step 4. Place material under presser foot and sew blind hem automatically.
Blind hem completed.