Costura para bordar, Costura para remendar – SINGER W915 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Page 41
:J<;CtÍOr¡
FREE HAND EMBROIDERY
Set the machine as shown.
Remove the presser foot.
Unscrew
the
presser
foot
holder screw and remove the
presser foot holder. Place the
darning plate on the needle
plate over the feed teeth.
To keep from seeing bobbin
thread pulled up to the right'top
side, reduce the upper thread
tension slightly.
For a beautiful embroidery
finish, it is important to use
correct needles and thread.
Use embroidery thread for the
upper thread and thinner thread
of the same kind and color for
the bobbin thread.
Trace your design on fabric and
center it in the embroidery
hoop. Make sure the fabric is
taut.
Español
Needle
Thread
No. 9
120 ~ 100
No. 11
100 ~ 80
No. 14
60 ~ 50
COSTURA PARA BORDAR
Preparar la máquina como se
indica. Quitar el pie prénsatela y
el soporte con el tornillo.
Para evitar que se tire el hilo
inferior reducir la tensión del hilo
superior.
Para hacer un buen bordado es
importante usar las agujas e hilos
apropiados.
Usar hilo de seda en la parte
superior, y en la parte inferior
(carrete) uno más delgado del
mismo color.
Trazar el diseño sobre el material
y centrarlo en el bastidor.
Debe asegurarse que el material
esté estirado.
Aguja
Hilo
No. 9
120 ~100
No. 11
100 ~ 80
No. 14
60 ~ 50