SINGER W1268 - Manual (Page 11)

PLACING BOBBIN CASE IN SHUTTLE
Open hinged cover plate left of the needle.
(See 15, Fig. 1) Hold the bobbin case latch, (D),
Fig. 9, between the thumb and forefinger of the left
hand, with at least three inches of thread running
from the top of the bobbin case to the right. Insert
and center the bobbin case on the stud of the shuttle
A body, (C). Be sure
the bobbin case
finger, (E), enters
the shuttle race
notch, (A).
Press
the bobbin
case (B) into the
shuttle as far as
possible until latch
catches on the
center post of the
shuttle.
THEN release the bobbin case latch.
Press bobbin case again after latch has been
leased to make sure the bobbin case is locked
securely in place. Close the cover plate.
Fig. 10
Fig. 9
(D).
re-