SINGER W1268 - Manual (Page 26)

24
4.
5.
When
1 .
2 .
3.
4.
5.
Clean the shuttle race, the shuttle, and shuttle race cover by removing all threads, lint, etc.
Apply a drop of oil with finger tip to outer edge of shuttle,
the cleaning has been completed, proceed as follows to repace the shuttle assembly:
Turn the balance wheel until the needle reaches its highest position.
Place shuttle body, (D), against shuttle driver and adjust into position.
Replace shuttle race cover, (C), fitting pin at lower edge into notch, and lock into position
with shuttle race cover clamps, (B), making certain the clamps have been snapped securely
into position.
Put bobbin into the bobbin case.
Put the bobbin case into the shuttle race, fitting tongue into notch E of race cover.
L
ACCESSORIES
1 Plastic Oiler 10
2 Package of needles 11
3 Bobbins (3) 12
4 Felt Washers 13
(for spool pins)
5 Needle Plate for 14
Straight Sewing
6 Small Screw Driver
7 Large Screw Driver
8 Quilter Guide
9 Cloth Guide
Thumb Screw
Button Sewing Foot
Buttonhole Foot
Presser Foot for
Straight Sewing
Small Hemmer Foot