Upper threading – SINGER W1268 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Jr.
• A
—B
UPPER THREADING
1.
Turn the balance wheel toward you to raise the take-
up and needle to their highest position.
2. Place spool of thread on spool pin.
3.
lead thread under arm thread guide A and by a cir
cular motion with your left hand lead thread through
guide.
4. down and around one set of tension discs B from right
to left.
5.
into notch on the right hand side of check spring C
over threaded discs.
6
. under thread guide bar and into guide D.
7. Up into take-up lever from right to left.
8
. Down through guide in thread bar D again.
9. Into guide inside face plate.
10. Through needle clamp guide and into needle from front to back pulling three to four inches
of through needle.
Hold the end of upper thread loosely and turn hand wheel toward you until the needle goes
all the way down and comes back up. A loop (Fig. 11) will be formed over the upper thread
which then can be pulled out straight. Place both thread ends under the slot of the presser foot
and draw toward the back of the machine, leaving both threads three or four inches long.
Fig. 11