Features & controls, A caution, Pi (b)—choke lever – Troy-Bilt 13034 User Manual
Page 12: 2 (c)—throttle lever, 0)—light switch, O (e)—attachment/pto drive switch, F)—pto indicator light, G) —hour meter (optional—standard on model 13037, H) —^ammeter [optional—standard on model 13037, I) —safety start indicator light
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 4
Features & Controls
A
CAUTION
KNOW THE LOCATION AND FUNCTION OF
ALL CONTROLS BEFORE OPERATING
UNIT. KNOW HOW TO STOP ENGINE AND
AHACHMENTS QUICKLY IN CASE OF
EMERGENCY.
(A,
Fig.
4-1)—
Ignition / Starter Switch
Note: Always remove ignition key
whenever unit is unattended to prevent
children or unauthorized persons from
starting unit.
Controls power to main systems. An
automotive-type, three-position switch:
Stops engine.
Starts engine. Release when engine
starts.
After starting, key returns to this
position.
Note: Battery will discharge (and hour
meter will run) if ignition switch is on
when engine is not running.
[PI (B)—Choke Lever
Regulates fuel-air mixture to engine.
Close choke (move lever up) when starting
a cold engine. As engine warms up, open
choke (move lever down). A warm engine
requires little or no choking.
2 (C)—Throttle Lever
Controls engine speed. Always run engine
at full throttle.
Note: Engine lubrication and cooling
systems operate best at full throttle.
Operating engine at less than full throttle
for extended periods can effect
performance of this system. Low throttle
settings can also discharge battery.
(0)—Light Switch
Controls headlights. Press top of switch to
turn lights on, press bottom to turn off.
O (E)—Attachment/PTO Drive Switch
Controls power to attachments. Press top
of switch to engage, press bottom to
disengage.
(F)—PTO Indicator Light
Lights up when attachment/PTO drive is
engaged.
(G) —Hour Meter (Optional—standard on
model 13037]
Registers hours of use. Activates when the
engine is running or when the ignition
switch is on.
(H) —^Ammeter [Optional—standard on
model 13037]
Measures battery charge. Activates when
engine is running.
(I) —Safety Start Indicator Light
Unit will not run when this light is on. For
a more detailed description of the safety
interlock system, see ’’Interlock System
Test Procedure,” Section 5 “Operation”.
(J) —Cruise Control Switch
[Optional-standard on model 13037]
Activates/deactivates cruise control.
Cruise control automatically maintains
constant travel speed. See "Cruise Control'
in Section 5 “Operation” for operating
instructions.
(K)—Cruise Indicator Light
[Optional—standard on model 13037]
Lights when cruise control is activated.
12