Fuel filter, Air cleaner, Model 13037 – Troy-Bilt 13034 User Manual
Page 25: Carburetor, Battery, A warning, Models 13034, fio 6-8 13035 & 13036, Maintenance (continued)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Maintenance (continued)
Fig. 6-6
Fuel Filter
Air Cleaner
Fig. 6-7
Model 13037
• Wash foam pre-cleaner (A) in liquid
detergent and warm water. Squeeze dry in
a clean cloth.
• Saturate foam pre-cleaner in clean
engine oil. Wrap in clean, absorbent cloth
and squeeze to remove a//excess engine
oil.
• Clean or replace paper cartridge (B) if
necessary. To clean: Tap gently against a
flat surface. If very dirty, replace or wash
in non-sudsing detergent and warm water.
Rinse thoroughly with clean water from
inside out. Thoroughly air dry.
• Reassemble air cleaner components.
Tighten knobs (D) securely. Clip cover
assembly (E) onto air cleaner body.
Carburetor
The carburetor is adjusted at the factory.
It should not need to be reset. If a black
exhaust is noted, check the air cleaner
first. An over-rich mixture is usually
caused by a poorly serviced or clogged air
cleaner element, not an improperly
adjusted carburetor. If readjustment is
necessary, refer to engine manual or
contact your dealer for servicing.
Battery
A
WARNING
Air Cleaner
Models 13034,
Fio 6-8
13035 & 13036
ELECTROLYTE CAN CAUSE SEVERE
BURNS AND BLINDNESS. ALWAYS
WEAR SAFETY GOGGLES WHEN
WORKING AROUND BAHERIES.
Keep cables and terminals clean. If cables
are corroded, clean them. After cleaning,
apply a light coat of petroleum jelly or
grease to terminals and bolts. ALWAYS
CONNECT THE NEGATIVE (-) TERMINAL
LAST.
Electrolyte should be level with bottom
edge of cell. See Figure 6-9. Fill with
distilled water only. Operating unit with
battery electrolyte level too low can
damage battery. If rapid loss of electrolyte
is observed, or if you experience electrical
or starting problems, contact your local
dealer.
Remove battery cables before removing
battery. Remove negative (-) cable first,
then positive (+) cable. Always check
polarity of battery terminals. Make sure
battery is not reversed. Negative (-) cable
is ground.
CHARGING: Remove filler caps. Charge at
2 amps until specific gravity reading is
1.265 to 1.275. Charging may take several
hours.
Fill to here
Fig 6-9 Battery Electrolyte Level
25