Troy-Bilt 13034 - Manual (Page 23)

Maintenance (continued)
hair pin (Z, Fig. 6-1). Pull pivot pin (Y) into
frame until it clears hood. Unplug
headlight harness from headlights.
Remove hood.
rotate pivot pin to access hole). Retain
pivot pin and hood with hair pin (Z).
A
CAUTION
HOOD RETAINING HARDWARE MAY
BECOME HOT FROM ENGINE EXHAUST.
BURNS MAY RESULT. DO NOT REMOVE
HOOD WITHOUT FIRST STOPPING
ENGINE AND ALLOWING THESE PARTS
TO COOL.
A
CAUTION
DO NOT RUN ENGINE WITH HOOD OPEN.
HOOD DAMAGE MAY OCCUR.
Engine Service
For complete engine service, contact an
authorized engine dealer. To locate an
authorized engine dealer, refer to the
“Yellow Pages” under “Engines—
Gasoline” or “Gasoline—Engines”.
Provide the dealer with the engine model
and serial numbers. Routine engine
service is described below. For more
detailed engine service information, refer
to the engine manual provided with your
unit. Refer to the serial number tag on
engine to determine the specific engine
model, type and specification numbers.
Hood Installation
Insert right side of hood onto pivot on
tractor frame. Insert pivot pin (Y) so the
outside end is flush with the outside of
frame. Position pivot hole in left side of
hood (X) over pivot pin (Y).
Engine Oil
Engine oil level must be between “ADD”
and “FULL” marks on dipstick at all times.
Check before each use.
CHECK OIL LEVEL:
Clean area around dipstick (A, Fig. 6-2) so
dirt does not fall into crankcase when
dipstick is removed.
Remove dipstick. Oil level must be
between “ADD” and “FULL” marks on
dipstick. Do not overfill. Oil level must not
exceed “FULL” mark on dipstick.
ADD OIL; Remove oil fill cap (A, Fig. 6-2)
and add oil.
NEW ENGINE: Change oil after first 5
hours of use, then change oil regularly as
specified on the lubrication chart on page
33.
Change Oil: Change oil as specified in
engine manual. Drain oil while it is hot.
Hot oil flows more freely and carries away
more impurities.
' Remove oil fill cap (A, Fig. 6-3).
• Remove protective cap (W) to expose oil
drain port (U) on oil drain fixture (T).
• Push oil drain hose (S) (included with
unit) onto oil drain fixture. Route other
end of hose to an appropriate waste oil
collection container.
• Twist oil drain fixture to open position.
Pull out. Drain oil completely.
• Push in and twist oil drain fixture to the
closed position. Remove and store hose
(S). Replace protective cap (W).
• Re-fill engine with oil through dipstick
opening. See engine manual for correct oil
specifications. Fill to level between “ADD”
and “FULL” marks on dipstick.
For complete engine lubrication
information, including engine oil
specifications & capacities, refer to the
engine manual provided with your unit.
23