Storage – Troy-Bilt 13034 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 7
Storage
When storing this unit for more than 30
days;
Add a gasoline stabilizer to fuel or move
unit outside and run until engine stops
from lack of fuel.
Remove key from ignition.
Lower any mounted attachment to ground.
Place attachment/PTO switch into the
“OFF” position.
Allow engine to cool and clean dirt and
debris from unit. Thoroughly clean engine
cooling fins, engine flywheel screen and
transmission cooling fins.
Change engine oil. See page 23.
Remove, clean and re-gap spark plug.
Reset gap according to specifications in
engine manual. See page 26.
Re-install spark plug. Replace plug if badly
worn. Leave spark plug wire disconnected.
Clean or replace engine air filter if
necessary (see page 24).
Check fuel filter and replace if necessary
(see page 24).
Check battery electrolyte level and add
distilled water only if necessary (see page
25). Charge battery once a month during
storage. Charge at 2 amps until specific
gravity reading is 1.265 to 1.275. Store
battery at 20° F (7°C) to 50° F O0°C).
Clean battery posts and coat with
petroleum jelly.
Apply rust preventative to surfaces subject
to corrosion. Apply touch-up paint to
surfaces where paint has chipped.
Apply a good grade of automotive wax to
hood.
Store unit in a dry, secure location.
34