Cisco 10BASE-FL - Manual (Page 16)

16 PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
VIP2 and the 5EFL Port Adapter
Step 11 Carefully slide the new port adapter into the port adapter slot until the connector on the
port adapter is completely mated with the connector on the motherboard.
Figure 12 Port Adapter Installed in a Port Adapter Slot (Partial Port Adapter View)
Step 12 Replace the screw in the rear of the port adapter slot. (See Figure 9 for its location.) Do
not overtighten this screw.
Step 13 Reinstall the VIP2 in the system. (Follow the steps in the section “Installing a VIP2” in
the configuration note Second-Generation Versatile Interface Processor (VIP2)
Installation and Configuration, which shipped with your VIP2.)
Step 14 If disconnected, reconnect the interface cables to the port adapters.
This completes the procedure for installing a new port adapter or replacing a port adapter on a VIP2.
H3152