Cisco 10BASE-FL User Manual
Page 27
PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration 27
Installing or Replacing a Port Adapter in Cisco 7200 Series Routers
Step 3
Grasp the handle on the port adapter and pull the port adapter from the midplane, about
halfway out of its slot. If you are removing a blank port adapter, pull the blank port
adapter from the port adapter slot.
Note
As you disengage the port adapter from the router midplane, OIR administratively shuts down
all active interfaces on the port adapter.
Step 4
With the port adapter halfway out of the slot, disconnect all cables from the port adapter.
Step 5
After disconnecting the cables, pull the port adapter from its port adapter slot.
Caution
Always handle the port adapter by the carrier edges and handle; never touch the port adapter’s
components or connector pins. (Refer to Figure 17.)
Figure 17
Handling a Port Adapter
Step 6
Place the port adapter on an antistatic surface with its components facing upward, or in a
static shielding bag. If the port adapter will be returned to the factory, immediately place
it in a static shielding bag.
This completes the procedure for removing a port adapter from a Cisco 7200 series router.
H6420
Metal carrier
Printed circuit board