Generac Power Systems MC User Manual
Page 63
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3,2,1,20~SelQcc a stud from the
kit that is long enough so that,
when the stud is threaded into
the engine crankshaft, the slot
ted end of the stud will extend
approximately
Inch into the
rotor shaft. Thread the stud in
to the engine crankshaft.
3,2,1,22-Remove the ignition stat
or.
3,2,1,21-Thread the 5/16-24 bolt
(included with rotor removal kit)
into the rotor shaft until It Is
fiinnly seated against the stud.
Tighten the bolt against the stud
and tap the bolt head with a mal
let, Continue tightening and cap
ping until rotor is free. Remove
Che rotor and fan assembly.
3.2.2-INSPECTION AND REPAIR
3,2,2,1- GENERAL
Inspect wiring for pinching, obvious damage, defective insulation.
Clean all parts and Inspect for-obvious damage, cracks, etc. Check
connector plugs and receptacles for damage, pins pushed out of
sockets, etc. Repair or replace damaged, defective parts as requir*
ed.
3 . 2 - 4