Shafl – Generac Power Systems MC User Manual

Page 74

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

3.3.1.17-Remove governor

shafL

retaining clip and governor

shaft.

3.3.1.19-Remove bolts that ret­

ain counterbalance cover.

3.3.1.21-Remove

counterbalance

assembly.

3.3.1.18-Remove oil stopper from

engine bearing cover.

3.3.1.20-InstaII a bolt into the

threaded hole at top of counter­

balance cover. Tighten bolt aga­

inst counterbalance shaft until

cover is free of shaft, then i*e-

move cover.

3.3.1.22-$him washers are used at

bearing cover end of crankshaft

to establish crankshaft end play.

Check uumber of shims- during re­

assembly, the same number of shims

must he used.

3.3-A

Advertising
See also other documents in the category Generac Power Systems For the car: