American Dryer Corp. AD-400 - Manual (Page 15)

C. LEVELING THE DRYER
The dryer weighs 9,800 pouitds. It must be installed on a level floor that can support its weight.
Place a large level on all four sides of the dryer base to ensure it is level. If shimming is required, place
9-1/2-inch by 9-1/2-inch square pieces of sheet metal under the mounting pads of the dryer.
The dryer must be lagged to the floor through the holes in the mounting pads.
D. SERVICE CONNECTIONS
1. Electrical Service
The electrical power is connected to the dryer at the high voltage section of the control cabinet. On the
AD-400 dryer, this section is located at the bottom left of the front enclosure.
The AD-400 must be supplied with two (2) independent input power lines. One electric service feeds the
dryer itself, and the other, the safety sprinkler system. Both input lines must be independent of each
other and individually protected by their own individual fused disconnects.
I NOTE: The AD-400 will not operate without pewer fed to the safety sprinkler system.
Feed the electrical service cables to the dryer using the pre-punched knockouts at the bottom section of
the electrical cabinet right wall.
Connect the input power lines to the power distribution terminals mounted at the bottom on the panel
inside the enclosure.
Connect the ground wires directly to the ground lug located at the same approximate location.
Before turning the power on to the dryer, measure the supply voltage to ensure that it matches the dryer's
sp>ecified input voltage. This input voltage is marked on the aluminum data plate located on the inner
right wall of the electrical cabinet door.
AD-400
Gas/Steam Electrical Sp>ecifications
Voltage (V) Phase Wires Current (A) Fuses Breakers
208 3 3,4 86 150 150
240 3 3,4 75 125 150
380 3 3,4 47 75 100
416 3 3,4 43 70 90
460 3 3,4 39 70 90
13