Throttle control, Drive clutch control, Ignition switch – Bolens 126-216-000 User Manual
Page 10: Operation, Keep hands and feet away, Figure 19, Note, Before starting, Caution, Danger
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/723580/10/background.png)
THROTTLE CONTROL
The throttle control is located on the left side of the up
per handle. It is used to regulate the engine sp(;ed. The
engine should be started with the engine in the CHOKE
position.
Ac
WARNING
The throttle control
to stop the engine.
cannot be use d
DRIVE CLUTCH CONTROL
Squeezing the drive clutch control engages t ie drive
mechanism to the rear wheels. Releasing th
3
clutch
control stops the rear wheels from driving. Rel<;ase the
drive clutch control to slow down when negoti iting an
obstacle, making a turn or stopping. See figure 18.
IGNITION SWITCH
The ignition switch is located on the left side o1 handle
panel. It is used for starting only. See figure 18.
OPERATION
Caution
!
D o N o t O p e r a t e M o w e r U n l e s s l T
G u a r d O r E n t i r e G r a s s c a t c h e r I s
I t s P r o p e r P l a c e .
I
KEEP HANDS and FEET AWAY
DANGER
m
FIGURE 19.
Keep hands and feet away from the chute area on cut
ting deck. See figure 19.
NOTE
For shipping purposes your mower
is set with the wheels in a low cut
ting
height
position.
For
best
results raise the cutting position un
til it is determined which height is
best
for
your
lawn.
See
cutting
height adjustment section.
BEFORE STARTING
A
I WARNING {
The battery contains corrosive fluid and toxic material.
HANDLE WITH CARE. Keep away from children. Do
not puncture, disassemble, mutilate or incinerate. Ex
plosive gases could be vented during charging or
discharging. Use in a well-ventilated area, away from
sources of ignition.
1. Charge battery for 16 hours before initial use. DO
NOT CHARGE LONGER THAN 20 HOURS.
A
CAUTION
Use only the battery charger sup
plied with this mower.
To charge the battery, first remove the protective
cap from the end of the battery pack lead. See
figure 10. Always plug charger lead into battery
pack lead before inserting battery charger plug into
120 volt standard household outlet.
After charging, disconnect battery charger plug
from household outlet first, then disconnect
charger lead from battery pack lead.
AC
WARNING
Do not remove the battery pack from
the
handle
panel
for
any
reason
other
than
replacement.
When
re
placing the battery pack, refer to
instructions
in
Maintenance
sec
tion.
2. Fill sump with oil as instructed in the separate
engine manual packed with your unit.
3. Fill fuel tank, using clean, fresh, unleaded, low-lead
or regular grade leaded gasoline. Fill tank com
pletely!
DO NOT MIX OIL WITH GASOLINE.
10