Bolens 126-216-000 - Manual (Page 4)

NOTE
This unit is shipped WITHOUT GAii-
OLINE or OIL. After assembly, sea
separate engine manual for proper
fuel
and engine oil recommendc-
tions.
w w
ASSEMBLY INSTRUCTIONS
FIGURE 1.
FIGURE 3.
NOTE
Reference to right or left hand side
of the mower is observed from the
operating position.
Contents of Hardware Pack: (See Figure 1)
A (1) Battery Charger (Not Shown)
B (2) Hairpin Cotters
C (2) Lock Washers 5/16" I.D.
—D (2) Hex Nuts 5/16-18 Thread
E (1) Curved Head Carriage Bolt
F (2) Cable Ties
G (2) Plastic Cable Anchors
H (1) Cable Clamp (Not Shown)
I (1) Plastic Cap
J (2) Phillips Head Screws
K (2) Ignition Keys (Not Shown)
Loose Parts in Carton:
(1) Lower Handle
(1) Upper Handle
(1) Side Chute Deflector
(1) Grass Catcher Handle
(1) Front Catcher Frame
(1) Grass Catcher Bag
1. Remove lawn mower and loose parts from carton.
Make certain all parts and literature have been
removed from the carton before the carton is
discarded.
2. Extend all control cables and place on the floor.
Be careful not to bend or kink control cables.
- 3. For shipping purposes your mower is set with the
wheels in the lowest cutting height position. Raise
the mower to the highest setting for assembly of
lower handle.
4. Attach the lower handle by placing the bottom
holes in the lower handle over the weld pins on the
handle wheel bracket assemblies. Make certain the
instruction label on the lower handle can be read
from the operating position. Secure with hairpin
cotters (B) in inner holes on weld pins. See figure 2.
NOTE
It may be necessary to bend the
ends of the lower handle inward
slightly to obtain a tight fit against
the handle mount brackets.
Place the upper handle in position over the lower
handle. The control housing must be on the left
hand side of the handle. Secure the upper handle
using the curved head bolt (E), lock washer (C) and
hex nut (D) as shown in figure 3.