Warning – Bolens 126-216-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6.
The brake cabfe is attached to the engine. Route
the brake cable through the opening beneath the
catcher panel, inside the handle mount bracket
and under the lower handle. Place the end of the
brake cable into the upper hole on the bottom of
the control housing, and through the slot in the side
—of the housing as shown in figure 4. The angle of
the flange on the plastic fitting must be positioned
downward as shown. Be careful not to bend or kink
the cable.
Ai
WARNING
j
Brake cable must be assembled as
shown for proper blade brake opera
tion.
FIGURE 4.
7. Snap the plastic fitting on the end of the cable in
to the control housing. Hook the “Z” end of the
brake cable into the hole in the blade control han-
—die. See figure 5.
Q
^1
q;2>sLow
8.
Move throttle control lever on handle forward until
it stops in FAST position.
(Do not push all the way
----- fonward to CHOKE position.) See figure 6.
FIGURE 6.