To convert mower to side discharge, Ac warning, Blade control handle – Bolens 126-216-000 User Manual
Page 9: Ac v, Controls
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO CONVERT MOWER TO SIDE DISCHARGE
To convert your mower to a side discharge unit, remove
only the grass bag and top discharge chute. It is not
necessary to remove the catcher panel and brackets.
To remove the top discharge chute, proceed as follows.
-See figures 16 and 17.
1. Remove the two wing nuts and flat washers which
secure the top discarge chute to the side of the
deck.
2. Lift up on the front edge of the discharge chute,
then slide it toward the side, removing it from the
bolts in the side of the deck.
3. Attach the side chute deflector by first placing it
over the rear bolt in the side of the deck, then over
the front bolt and sliding it into position. Secure
with the hardware removed in step one.
AC
WARNING
\
Never
operate
your
unit
without
either the side chute deflector or
■entire
top
discharge
chute
and
catcher panel assembly in place.
FIGURE 17.
CONTROLS
Drive
BLADE CONTROL HANDLE
WARNING
THIS CONTROL MECHANISM IS A
SAFETY DEVICE NEVER ATTEMPT
TO BYPASS ITS O P E R A T I O N S
The blade control handle is located on the upper han
dle of the mower. See figure 18. The blade control han
dle must be depressed in order to operate the unit.
Release the blade control handle to stop the engine and
blade.
Ac V
a
*
rn
I
ng
*J
The blade will be rotating whenever
the engine is running.