Installation instructions, Before using your wine refrigerator, Installing your wine refrigerator – NewAir AW-281E User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS
Before Using Your Wine Refrigerator:
•
Remove exterior and interior packing material.
•
Check to make sure the following parts are included:
♦
6 slide-out shelves
♦
Door handle and 2 screws
♦
Instruction manual
•
Before connecting the appliance to the power supply^ let it stand upright for
approximately 2 hours. This will reduce the possibility of raalftmction in the cooling
system that may have occurred from handling during transportation.
•
Clean the wine cooler's interior surface with lukewarm water using a soft cloth
before using the wine cooler for the ffrst time.
Installing Your Wine Refrigerator:
•
Place the appliance on a floor that is strong enough to support it when it is fully
loaded. To level the wine refrigerator, adjust the front feet located on the bottom of
the appliance-
•
Keep the wine cooler away from direct sunlight and excess heat sources such as
stoves, heaters, radiators, etc. Direct sunlight may affect the unit's acrylic coating
and heat sources may increase electricity consumption. Extreme cold or hot
ambient temperatures may also cause the appliance to perform improperly,
•
This unit can be recessed. Please allow a 1” inch clearance all around the unit.